Mitsubishi 1993 3000GT Technical Information Manual page 53

Item No.
27 Power steering fluid pressure switch
28 Air conditioner switch
33 Electric load switch
34 Air flow sensor reset signal
36 Ignition timing adjustment mode
37 Volumetric efficiency
38 Crank angle sensor output (readable at 2,000 rpm or less)
39 Oxygen sensor output (Front bank) <Europe, Hong Kong and Singapore>
41 Injector drive time (Rear bank)
44 Ignition advance angle value
45 ISC stepper motor position
47 Injector drive time (Front bank)
49 Air conditioner relay
ACTUATOR TESTS
The actuator test items are shown in the following table.
Item No.
01
02
03
04
05
06
07
08
09
10
12
13
17
OIL LEVEL WARNING SYSTEM
This system is the same as that of the conventional 6G72 engine.
ENGINE - Control System
Service data item
Purge control solenoid valve: ON <Europe, Hong Kong and Singapore>
Fuel pressure control valve: ON
EGR control solenoid valve: ON <Except for Australia>
Waste gate solenoid valve: ON
Fuel pump relay No.2: ON (Current flows via the resistor)
Ignition timing: 5º BTDC
NOTE
The items that have been added to the conventional
system are shown in bold letters.
Actuator test item
NO.1 injector: OFF
NO.2 injector: OFF
NO.3 injector: OFF
NO.4 injector: OFF
NO.5 injector: OFF
NO.6 injector: OFF
Fuel pump: ON
1-29
Unit
ON - OFF
ON - OFF
I
ON - OFF
ON - OFF
ON - OFF
%
RPM
mV
mS
ºBTDC,ºATDC
STEP
mS
ON - OFF