Cobra DCX65 2003 Owner's And Service Manual page 34

may drain.
6. To remove the slide from the cable, hold the slide in one hand and compress
the spring into the cap with the other.
7. While compressing the spring, hold the slide upside down such that the
retaining plate drops free.
8. Snake the cable through the proper grooves to remove the cable from the
slide.
9. With the slide free from the cable, lightly push on the pointed end of the jet
needle to remove it from the slide.
10. Make note of what groove the clip is in on the end of the needle (groove one
is at the top and groove 5 is furthest away from the top).
11. To adjust richer, move the clip further from the top (to a higher number) and
conversely to adjust the bike leaner, move the clip closer to the top.
NOTE:
Make adjustment by one step at a time.
NOTE:
The clip can be easily removed and reinstalled by pressing the needle (with the
clip in position) against the top of a table.
33