HoMedics NEWA User Manual page 11

2
2
10
• Pressing the power button will start or stop energy delivery.
• Press and release the power button to start energy delivery.
The LED will start blinking.
It is important to have the active tip in full contact with the skin at all time
during treatment.
Step 7 – Treatment
• Treat the entire treatment area in constant circular motion.
• You need to maintain circular motion of the device during
treatment mode.
• You should feel a warm, pleasant sensation as you move the device over
the treatment area. This means that the Newa is working.
• It is important you maintain a reasonable movement speed
as demonstrated in the instructional DVD.
• Once you have reached the optimal skin temperature range the LED turns
Green. Keep treating the entire area untill the 4 minute treatment cycle is
complete.
• A vibration will indicate that the 4 minute treatment cycle of the area is completed
Step 8 – Control The Heating
You can control the heating by changing the size of the treatment area:
• If you feel your skin is only mildly heated you can decrease the size of
the circular motion to narrow down the treatment area.
• If your skin feels too warm, try increase the size of your circles.
If this does not help, stop the treatment by pressing the power button
and change the treatment level to "1".
Step 9 – Adjust Treatment Level
We recommend you start with the High heating level ("2" mode), but if you
find the sensation uncomfortable, you may select the lower setting.
To change the treatment level, if there is energy delivery (LED is blinking)
press and release the power button to stop energy delivery, then remove
the Newa device off the skin and change the Switch to mode "1".
Step 10 – Move to the Next Treatment Area
When treatment of the first area is completed (total of 4 minutes):
• The LED will stop blinking and a vibration will be felt indicating no
energy delivery.
• Apply more Newa activator gel on the electrode area, continue to the next
treatment area and repeat the procedure.