Table of Contents
Advertisement
V8088
4.1 Disassembly Introduction
The V8088 has no screws to hold it together and is held together by plastic catches, these are delicate
and should be parted using the upmost care. Also the display flex cable can be torn or broken without
too much stress being applied so again caution should be taken on dissassembly or assembly.
Ensure that a properly grounded high impedance conductive wrist strap is used whilst performing any
tasks during the disassembly and assembly of the unit
Avoid stressing the plastics in any way to avoid damage to either the plastics or internal components.
Many of the intergrated devices used in this equipment are vulnerable to damage from
electro-static charges. Ensure that adequate static protection is in place when handling,
shipping and servicing the internal components of this equipment.
4.2
Recommended Tools
The following tools are recommended for use during the assembly / disassembly of the V8088.
• Anti-static Mat Kit - 0180386A82, includes:
Antistatic mat 66-80387A95
Ground Cord 66-80334B36
Wrist Band 42-80385A59
• Plastic Bladed Tool SLN7223A
• Plastic Antenna Removal Tool: 0-00-00-30007
• Light guide removal Tool: This tool requires modification, will be available shortly
• Flex Removal Pliers: 0-00-00-30002
• Flip Opening Tool: 0-00-00-30008
These can be ordered via the test AMS website:
A Password for this website can be set up through Axel Schneider WFAS120
4.3
Disassembly Procedure
The following set of diagrams will demonstrate the correct sequence and action required to disassemble
the V8088
The use of the exploded diagram on pages 23 may be of some assistance for part recognition.
4.4
Assembly Procedure
Once the unit is disassembled and the repair is carried out, the unit must then be reassembled, this is
carried out in the exact reverse order as the disassembly.
!! CAUTION !!
http://212.112.205.178
Advertisement
Table of Contents
