Panasonic VIERA TX-37LZD81AZ Operating Instructions Manual page 48

FAQs
Sound is unusual
Pictures from external equipment
are unusual when the equipment
is connected via HDMI
•
Due to the digital reception technologies involved, quality of the Digital TV signals may be relatively low in
some cases, despite good reception of Analogue TV programmes.
Unable to receive signals
with a high-performance
aerial
Interference or
frozen / disappearing
image in Digital TV
TV goes into "Standby mode"
The remote control does not
work
48
Problem
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
Check the "HDMI1 / 3 Input" setting in the Sound Menu. (p. 24)
•
If digital sound connection has a problem, select analogue sound
connection. (p. 35)
•
Is the HDMI cable connected properly? (p. 42)
•
Turn Off the TV and equipment, then turn them On again.
•
Check an input signal from the equipment. (p. 46)
•
Use an equipment compliant with EIA/CEA-861/861B.
•
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
Aerial
Input
terminal
VCR
•
Check "Digital TV Signal Condition". (p. 29)
If "Signal Quality" or "Signal Strength" are displayed in red, check
aerial.
If problem persists, consult your local Panasonic dealer.
•
Turn the TV off with the Mains power On / Off switch, then turn it
On again.
•
Off Timer function is activated.
•
The TV enters "Standby mode" about 30 mins. after analogue
broadcasting ends.
•
Are the batteries installed correctly? (p. 8)
•
Has the TV been switched On?
Actions
(Individual aerial)
Splitter
Aerial Output
Aerial Input
Aerial Output
(Individual aerial)