Installing The Battery; Charging The Battery - Motorola V620 User Manual

To maximise your battery's performance:
• Always use Motorola Original batteries and battery chargers.
The phone warranty does not cover damage caused from
using non-Motorola batteries and/or battery chargers.
• New batteries or batteries that have been stored for a long
time may require a longer charge time.
• Maintain the battery at or near room temperature when
charging.
• Do not expose batteries to temperatures below -10°C (14°F)
or above 45°C (113°F). Always take your phone with you
when you leave your vehicle.
• When you do not intend to use a battery for a while, store it
uncharged in a cool, dark, dry place, such as a refrigerator.
• Batteries gradually wear down and require longer charging
times. This is normal. If you charge your battery regularly and
notice a decrease in talk time or an increase in charging time,
then it is probably time to purchase a new battery.
The rechargeable batteries that power this phone must
be disposed of properly and may need to be recycled.
Refer to your battery's label for battery type. Contact your
local recycling centre for proper disposal methods.
Warning: Never dispose of batteries in a fire because they may
explode.
18 - Getting Started

Charging the Battery

New batteries are shipped partially charged. Before you can use
your phone, you need to install and charge the battery as described
below. Some batteries perform best after several full
charge/discharge cycles.
Action
1 Insert the travel charger
plug into your phone with
the release tab facing up.
Make sure that both of
the plug's connector
hooks engage to lock the
plug in place.
2 Plug the other end of the travel charger into the appropriate
electrical outlet.
Note: It make take up to 10 seconds for your phone to
provide a visible or audible indication that the battery is
charging.
3 When your phone indicates
tab and remove the travel charger.
Tip: You can safely leave the travel charger connected to the
phone after charging is complete. This will not damage the battery.
20 - Getting Started
, press the release

Installing the Battery

Your phone is designed to use only Motorola Original
batteries and accessories.
Note: Your phone is shipped with a protective clear
plastic liner covering the battery door latch. Remove the
liner to ensure that the battery door attaches and closes properly.
1.
3.
Turning Your Phone On
Action
1 Open your phone.
2 Press and hold the power key P
for 2 seconds to turn the phone
on.
Note: It may take up to 4 seconds
for the display to illuminate after
you turn the phone on.
3 If necessary, enter your SIM card PIN code and press
( + ) to unlock the SIM card.
Caution: If you enter an incorrect PIN code 3 times in a row,
your SIM card is disabled and your phone displays
.
4 If necessary, enter your 4-digit unlock code and press
( + ) to unlock the phone.
Turning Your Phone Off
Action
Press and hold the power key P for 2 seconds to turn the phone
off.
2.
Getting Started - 19
Getting Started - 21