Transmitter Handling; Fail Safe Adjustment - Carson Reflex Stick Pro 3 Instruction Manual

tranSmitter HanDLing

A. Throttle Stick
Forward/
Speed up
Neutral
Brake/
Slow down
Push the throttle stick for running forward and pull it
for breaking and running backward.
Throttle Trim
Channel 2
Steering trim (St. trim)
Move the trim tab to adjust the Steering Servo to the neutral
position.
throttle trim (tH. trim)
Move the trim tab to adjust the Throttle Servo (or the Speed
Controller) to the neutral position.

FaiL SaFe aDjuStment

1. Set the throttle and the steering stick to the neutral position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver will start to
flash.
4. Put the throttle trigger at the brake position, press the "F/S SET"
button, the LED should become solid.
5. For electric models, put the throttle trigger at the neutral posi-
tion when you are making the failsafe setting.
GB // 22
ATTENTIoN
Keep the transmitter and receiver not over 40 cm
apart when setting and binding.
Use the REV switch (TH REV + ST REV) to change
the direction of rotation.
LoW BATTERY ALARm
Throttle Trim
When the battery power is too low, cease
Channel 1
operation immediately.
Reflex Stick Pro3:
As soon as the receiver/transmitter signal is interrupted, the
receiver switches into the preset throttle failsafe setting.
B. Steering Stick
Move the steering stick to the left or to the right
according to the intended direction.