Memory Card; Charging The Battery; Using The Headset - Motorola QUENCH XT5 User Manual

Chapter 1: Getting started

Memory card

You will need a microSD
To install the memory card
1. Insert the memory card with the gold contacts
facing down.
2. Push the memory card until it clicks into place.
To remove the memory card
1. For safe removal of the memory card, tap
Application Drawer > Settings > SD card,
USB Mass storage & phone storage >
Unmount SD card.
2. Push the memory card down to eject it from the slot.

1.4 Charging the battery

The battery out of the box is only partially charged. To fully charge the battery,
charge it for 2 hours.
1. Open the Micro USB port cover.
2. Plug in the battery charger as shown in the diagram.
3. Plug the AC adaptor into the wall socket to start charging.
When the battery is charging, the red LED is activated;
the icon is also displayed in the status bar. When
the battery is fully charged, the red LED disappears and
the green LED is activated; if the device is turned on,
the icon is also displayed in the status bar.
NOTE:
• The battery can also be charged when you connect the device to a computer
with a USB cable.
• To ensure safety, do not remove the battery from the device while the AC
adaptor is connected or while it is being charged.

1.5 Using the headset

For hands-free conversation or to listen to music, plug a headset into the headset jack.
NOTE:
• When using a headset, your ability to hear outside sounds may be limited.
Do not use the headset if it will endanger you.
• Do not set the volume to its maximum with a headset as it may damage
your hearing.
5
®
card to store photos, music, videos and other data.