Table of Contents
Advertisement
Hoses:
Chambers:
Slack adjuster:
Drum:
Rims:
Lug nuts:
Hub oil seal:
Oil-lubricated front
wheel bearing:
2009 F-650/750 (f67)
Supplement
USA (fus)
Vehicle Inspection Guide
Front brakes
Check for cracked, worn or frayed hoses. Make
sure all couplings are secured.
Make sure brake chambers are not cracked or
dented and that they are securely mounted.
Check for broken, loose or missing parts. The
angle between the push rod and adjuster arm
should be approximately 90° when the brakes
are applied. When pulled by hand, the push
rod should not move more than approximately
one inch (2.5 cm).
Make sure there are no cracks, dents or holes
and no loose or missing bolts. Make sure brake
linings are not worn, dangerously thin or
contaminated by lubricant.
Front wheels
Check for damaged or bent rims. Rims should
not have welding repairs and no rust trails that
indicate it is loose on the wheel.
Make sure all lug nuts are present and not
loose (look for rust trails around the lug nuts).
There should be no cracks radiating from the
lug bolt holes or distortion of the bolt holes.
Check wheel hub oil seal for leaks, and if sight
glass if present, check to see that the oil level
is adequate.
If the hubcap has a transparent window, check
for proper lubrication level. If the hubcap does
not have a transparent window, remove the
rubber fill-plug and check for proper level.
17
Advertisement
Table of Contents
