Kenwood TK-3212L Service Manual page 6

TK-3212L
Key operation
Key
[Selector] Toggle between Zone selection and Channel selection.
[Side1] No action
[Side2] No action
[S] Enter the Item Selection mode
[A] Error tone sounds
[<B] Decrement the blinking Zone/Channel number by 1.
Press and hold to decrement in steps of 10.
[C>] Increment the blinking Zone/Channel number by 1.
Press and hold to decrement in steps of 10.
Note :
If a non-existing Zone-Channel is selected and the memory
for all 128 channels is already filled, an error tone will sound
and "MEM.FULL" will appear on the LCD for 2 seconds.
5-4. Item Selection Mode
In this mode, the following items can be selected.
• RX frequency
• RX signaling
• TX frequency
• TX signaling
• Wide/ Narrow
• RF power Hi/Low
• Scan Del/Add
• Beat shift on/off
• Compander on/off
When the [S] key is pressed in the Channel Selection mode,
the transceiver enters the Item Selection mode.
Key operation
Key
[Selector] The selected item changes
[Side1] No action
[Side2] No action
[S] Enter the Item Setting mode
[A] Return to the Channel Selection mode
[<B] Error tone sounds
[C>] Error tone sounds
5-5. Item Setting Mode
In this mode, the selected item in the Item Selection mode
can be programmed.
When the [S] key is pressed in the Item Selection mode,
the transceiver enters the Item Setting mode.
6
REALIGNMENT
Key Function
Key Function
The setup items for item setting mode are as follows.
Setup item Display
1. RX FREQ →
1.RX frequency
∗ ∗ ∗ . ∗ ∗ ∗ ∗ ∗
2. RX SIG →
2.RX signaling
TONE OFF/
QT ∗ ∗ ∗ .∗ /
DQT∗ ∗ ∗ N/
DQT∗ ∗ ∗ I
3. TX FREQ →
3.TX frequency
∗ ∗ ∗ . ∗ ∗ ∗ ∗ ∗
4. TX SIG →
4.TX signaling
TONE OFF/
QT ∗ ∗ ∗ .∗ /
DQT∗ ∗ ∗ N/
DQT∗ ∗ ∗ I
5. BAND ∗
5. Wide / Narrow
6.RF power Hi / Low 6. PWR ∗∗∗
7. SCN ∗∗∗
7.Scan Del / Add
8. SFT ∗∗∗
8.Beat shift on / off
9.Compander on / off 9. CMP ∗∗∗
Key operation
Key
[Selector] Changing the selection item (RX/ TX frequency and
RX/ TX signaling only)
[Side1] No action
[Side2] No action
[S] • Store the current settings and return to the Item
Selection mode.
• A MHz digit of the frequency blinks.
(RX/ TX frequency only)
• The icon of the current signaling configuration blinks.
(RX/ TX signaling only)
[A] Abort the current settings and return to the Item
Selection mode without backup.
[<B] Toggle/ Decrease the blinking value.
[C>] Toggle/ Increase the blinking value.
Remarks
Receive frequency
327.00000~550.00000MHz
Receive QT/DQT
Transmit frequency
327.00000~550.00000MHz
Transmit QT/DQT
W / N
HI / LOW
DEL / ADD
ON / OFF
ON / OFF
Key Function