Diagrams - Sony HCD-GN660 Service Manual

QQ
3 7 63 1515 0
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
specified.
• % : indicates tolerance.
f
• : internal component.
• 2 : nonflammable resistor.
• 5 : fusible resistor.
Note: The components identified by mark 0 or dotted line
with mark ! are critical for safety.
Replace only with part number specified.
• C : panel designation.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark: TUNER (FM/AM)
( ) : CD PLAY
< >: TAPE PLAY
[ ]: TAPE REC
* : Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Signal path.
TE
L 13942296513
F
: TUNER (FM/AM)
E
: TAPE PLAY (DECK A)
d
: TAPE PLAY (DECK B)
G
: RECORD
J
: CD PLAY (ANALOG OUT)
c
: CD PLAY (DIGITAL OUT)
j
: GAME IN (AUDIO)
k
: GAME IN (VIDEO)
N
: MIC INPUT
• Abbreviation
AUS : Australian model
E2 : 120V AC Area in E model
E3 : 240V AC Area in E model
E51 : Chilean and Peruvian model
MX : Mexican model
AR : Argentine model
www
.
http://www.xiaoyu163.com
1 / W or less unless otherwise
4
x ao u163
y
i
http://www.xiaoyu163.com
SECTION 7
2 9
8

DIAGRAMS

Note on Printed Wiring Boards:
Note:
• X : parts extracted from the component side.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Parts face side:
(Side A)
Pattern face side:
(Side B)
• Indication of transistor.
C
Q
B E
Q
B C E
Q
B C
Q Q
3 6 7 1 3 1 5
• Abbreviation
AUS : Australian model
E2 : 120V AC Area in E model
E3 : 240V AC Area in E model
E51 : Chilean and Peruvian model
MX : Mexican model
AR : Argentine model
co
.
HCD-GN660/GN770/GX9000
9 4 2 8
Parts on the parts face side seen from
the parts face are indicated.
Parts on the pattern face side seen from
the pattern face are indicated.
These are omitted.
These are omitted.
E
These are omitted.
0 5 8 2 9 9 4 2 8
m
9 9
9 9
25