MTD remington Shop Manual page 15

Wrench preventing the
flywheel from turning
flywheel
Figure 17
axle
Figure 18
13. Secure the pulley flywheel so that it will not spin
during removal of the crankshaft bolt. See Figure 17.
14. Remove the crankshaft bolt using a 9/16" wrench.
15. Remove the left wheel.
16. Slide the axle to the right until it clears the left side of
the frame. See Figure 18.
17. Slip the belt off of the pulley flywheel.
18. Remove the pulley flywheel.
19. Remove the belt.
20. Install the belt by following the previous steps in
reverse order.
21. Test run the trimmer mower in a safe area before
returning it to service.
22" Trimmer Mower
11