Table of Contents
Advertisement
3
Remove adhesive backing from and press key tabs
(supplied) onto UIM:
• Place
key at top position.
• Place \ key at bottom position.
4
Verify cable is fitted into a groove on the back of the
UIM. The cable must be contained in the slot to
provide a flat surface for mounting.
5
Connect cable connector P (shown on page 5) to the
vehicle integration kit connector B (shown on page 4).
6
Remove one side of mounting tape (supplied) and
press firmly onto rear of the UIM.
7
Remove other side of mounting tape and attach UIM to
flat spot location on your vehicle.
Use mounting bracket
To install the UIM using the mounting bracket:
Caution:
The location of the UIM must not interfere with
the vehicle's air bag deployment.
1
Clean mounting surface thoroughly with an alcohol
wipe (not supplied).
2
Select UIM orientation (controls on left or right of
display).
Note:
To change screen display orientation, see "Set
install preferences" on page 11.
3
Remove adhesive backing from and press key tabs
(supplied) onto UIM:
• Place
key at top position.
• Place \ key at bottom position.
4
Verify cable is fitted into a groove on the back of the
UIM. The cable must be contained in the slot to
provide a flat surface for mounting.
optimal for
right-handed
operation
optimal for
left-handed
operation
Installation
7
Hide quick links:
Advertisement
Table of Contents
