Maintenance And Inspection; Storage; Service And Repairs - Hitachi WH 8D2 Instruction Manual And Safety Instructions

MAINTENANCE AND INSPECTION

CAUTION: Pull out battery before doing any inspection or maintenance.
!
1. Checking the condition of the socket.
A worn or deformed hex or a square-holed socket will not give an adequate
tightness to the fitting between the nut or anvil, consequently resulting in loss of
tightening torque. Pay attention to wear of a socket holes periodically, and
replace with a new one if needed.
2 Check the Mounting Screws
Loose mounting screws are dangerous. Regularly inspect them and make sure
they are tight.
CAUTION: Using this power tool with loosen, screws is extremely dangerous.
!
3 Check for Dust
Dust may be removed with a soft cloth or a cloth dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner, for they may damage the
plastics.

STORAGE

Storing in a place below 104°F (40°C) and out of the reach of children.

SERVICE AND REPAIRS

All quality power tools will eventually require servicing or replacement of parts
because of wear from normal use. To assure that only authorized replacement parts
will be used, all service and repairs must be performed by a HITACHI AUTHORIZED
SERVICE CENTER, ONLY.
NOTE:
Specifications are subject to change without any obligation on the part of the
HITACHI.
25