Table of Contents
Advertisement
3.
Rotate the turn base slightly clockwise and coun-
terclockwise to seat the turn base in the 0° miter notch.
(Leave as it is if the pointer does not indicate 0°.)
4.
Loosen the hex socket bolt securing the guide
fence using the hex wrench.
1. Guide fence
2. Hex socket bolt
5.
Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
6.
Adjust the guide fence until it makes a perpendic-
ular angle with the blade using a triangular rule, try-
square, etc. Then securely tighten the hex socket bolt
on the guide fence in order starting from the right side.
1. Triangular rule
7.
Make sure that the pointer indicates 0° on the
miter scale. If the pointer does not indicate 0°, loosen
the screw which secures the pointer and adjust the
pointer so that it indicates 0°.
1
2
1. Screw
2. Miter scale
22 ENGLISH
1
1
3
3. Pointer
Bevel angle
0° bevel angle
2
2
1. Lever
2. Arm holder
adjusting bolt
1.
Push the carriage toward the guide fence and
tighten two clamp screws to secure the carriage.
2.
Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
3.
Loosen the lever at the rear of the tool.
4.
Turn the 0° bevel angle adjusting bolt (lower bolt)
on the right side of the arm two or three revolutions
counterclockwise to tilt the blade to the right.
5.
Turn the 0° bevel angle adjusting bolt clockwise
carefully until the side of the blade makes a perpendic-
ular angle with the top surface of the turn base. Use the
triangular rule, try-square, etc. as a guide. Then tighten
the lever securely.
1. Triangular rule
turn table
6.
Make sure that the pointer on the arm indicates 0°
on the bevel scale. If it does not indicate 0°, loosen the
screw which secures the pointer and adjust the pointer
so that it indicates 0°.
4
3
3. 0° degree bevel angle
4. Arm
5. Release button
1
2. Saw blade
3. Top surface of
1
5
2
3
Advertisement
Table of Contents
