Panasonic Toughbook CF-50 Series Reference Manual page 54

Dealing with Problems
Display (continued)
When you want to display
the fonts or icons at a
larger size
Windows XP
An error occurs or the
computer freezes while
using Dualview
Battery Indicator
The red indicator lights
The red indicator blinks
The orange indicator
blinks
Shutting Down
Windows cannot be shut
down or restarted
Standby/Hibernation Function
Unable to enter standby
or hibernation mode
Unable to automatically
enter standby or hiberna-
tion mode
The computer does not
resume
Touch Pad
Unable to input using the
touch pad
Change the settings as follows (for more details, refer to the Windows Help).
Windows 2000
1 Select [Start] - [Settings] - [Control Panel] - [Display] - [Appearance].
2 Select the scheme labeled "large" or "extra large" in [Scheme] to change the font
size, and select [Icon] in [Item] to change the icon size.]
3 Select [OK].
Windows XP
1 Select [start] - [Control Panel] - [Appearance and Themes] - [Display] - [Appear-
ance].
2 Select the font size in [Font size], and select [Effects] and then add the check mark
for [Use large icons] to increase the icon size.
3 Select [OK], then select [OK].
If you use a 3D screen saver while in Dualview mode at a high resolution, an error
may occur or the computer may freeze. Under these conditions, do not use a 3D
screen saver.
The battery level is low. Quickly save current data and power off your computer.
After connecting the AC adaptor or replacing the battery pack with a fully charged
one, turn your computer on.
The battery pack or recharging function may be defective. Quickly save current
data and power off your computer. Remove the battery pack and disconnect the
AC adaptor, then connect them again.
Check the model number of the battery pack. CF-VZSU18 (blue tab) cannot be
used with this computer. Use only the specified battery pack (CF-VZSU18A, yel-
low tab).
If the problem persists, contact Panasonic Technical Support.
Unable to recharge due to violation of temperature limits. The ambient tempera-
ture is outside the allowable range. Once the allowable range requirement is sat-
isfied, charging begins automatically.
When using the application, power consumption is high; therefore there is insuffi-
cient power to recharge the battery.
If a USB device is connected, try removing it.
If a USB device is connected to the computer (note: only for some USB devices),
remove the USB device temporarily. If the problem persists, restart the computer.
If an IEEE1394 device or other peripheral is connected to the computer, disconnect
the device.
Did you press the power switch and hold it for four seconds or more?
If you press the power switch and hold it for four seconds or more, the power will be
turned off forcibly. In this case, all unsaved data will be lost.
Has the Setup Utility been used to set [Touch Pad] to [Enable]? (
When mouse drivers are installed (e.g., Intellimouse), the touch pad is unable to
be used.
Has the touchpad driver been properly installed?
(Advanced)
54
page 44)