Pattern; Auto Scan - Lorex LZV2722 Instruction Manual

6
Controlling the PTZ Camera with your DVR

6.2.3 Pattern

Patterns automatically cycle the camera between two positions.
To create a pattern:
1. Click to open the aux menu.
2. Click the Pattern tab.
3. Under Pattern, enter the pattern you would like to configure.
4. Move the camera into the desired start position and click Begin.
5. Move the camera into the desired end position and click End.
To run a pattern:
• Under No., select the number of the pattern you would like to go to and click

6.2.4 Auto Scan

An auto scan automatically cycles between a left and right point.
To create a new auto scan:
1. Click to open the aux menu.
2. Click the Border tab.
3. Move the camera into the desired left position and click Left.
4. Move the camera into the desired right position and click Right.
To run an auto scan:
• Click .
#LX400025; r.30544/30780; en-US
.
15