Yamaha YST-RSW300 Service Manual page 7

3. Removal of Rear Panel Ass'y
a. Remove 8 screws (2). (Fig. 2)
* Screws (2) are identified with arrow marks ( ).
b. Pull out the rear panel ass'y together with the cover.
(Fig. 2)
c. Remove bush. (Fig. 2)
* The bush once removed cannot be reused. Be sure
to use a new bush for replacement.
Bottom side
to CB4
Rubber sheet and cloth
4. Removal of Front Panel Ass'y
* The front panel once removed cannot be reused.
Be sure to use a new front panel for replacement.
Before installing the new front panel, be sure to remove
the double sided adhesive tape remaining from the old
front panel completely.
a. Remove 2 knobs (4). (Fig. 3)
b. Insert L-shaped metal parts or the like into the volume
knob hole and high-cut knob hole in the front panel and
pull the panel gradually away from the cabinet to re-
move it.
d. Remove 2 screws (3). (Fig. 2)
* Screws (3) are identified with arrow marks ( ).
e. Remove the cover. (Fig. 2)
f. Disconnect the connectors (CB9 and CB10). (Fig. 2)
Cover
Bush
Rear panel ass'y
to CB10
2
3
to CB9
3
2
Fig. 2
c. Remove 2 screws (5). (Fig. 3)
d. Pull out the switch cover ass'y. (Fig. 3)
e. Remove bush. (Fig. 3)
* The bush once removed cannot be reused. Be sure
to use a new bush for replacement.
f. Remove the switch cover ass'y together with the cable/
CB9. (Fig. 3)
Front panel
Knob hole
Switch cover ass'y
L-shaped metal part
or the like
Front panel
Knob 4
When Checking the P.C.B.:
• Connect all the connectors removed during disassem-
bly back to the original positions.
• Spread cloth first and place the rear panel ass'y and
switch cover ass'y on it. (Fig. 4)
Rear panel ass'y
Rubber sheet and cloth
YST-RSW300
CB9
Cable
Bush
5
Fig. 3
Switch cover ass'y
Fig. 4
7