Table of Contents
Advertisement
HOME
TESTING/REPLACEMENT
Sidestand Switch
See
Figure 7-14.
The sidestand switch is a rotary type switch.
The switch completes a path to ground for the ignition relay
when the sidestand is in the retracted position. Test the
switch as follows:
1.
Remove heat shrink tubing from sidestand.
2.
Unplug the 2-place sidestand switch connector [60].
3.
Test the switch using an ohmmeter.
a.
With sidestand down (switch open), the switch
should show ∞ ohms (infinite ohms).
b.
With sidestand up (switch closed), the switch should
show 0 ohms or little resistance.
4.
Replace the assembly with a new switch if necessary.
See
2.40
SIDESTAND.
5.
Replace heat shrink tubing.
Clutch Switch
See
Figure 7-15.
The clutch switch attaches to the clutch con-
trol lever bracket. The switch completes a path to ground for
the ignition relay and the starter relay when the clutch is dis-
engaged. Test the switch as follows:
1.
Unplug the 2-place clutch switch connector [95].
2.
Test the switch using an ohmmeter.
a.
With clutch engaged (1) (switch open), the switch
should show ∞ ohms (infinite ohms).
b.
With clutch disengaged (2) (switch closed), the
switch should show 0 ohms or little resistance.
3.
Replace the assembly with a new switch if necessary.
See
2.24 CLUTCH HAND
7-16
2003 Buell XB9R: Electrical
LEVER.
8403a
Figure 7-14. Sidestand Switch
b0393x7x
1
2
3
1.
Clutch engaged (switch open)
2.
Clutch disengaged (switch closed)
3.
Connector [95]
Figure 7-15. Clutch Switch
Trigger
Button
Advertisement
Table of Contents
Troubleshooting
