Setup Menu Items - Yamaha aventage RX-AS710 Owner's Manual

Setup menu items

Menu Item
Auto Setup
Power Amp Assign
Configuration
Speaker
Manual Setup
Distance
Level
Parametric EQ
Test Tone
Delay Enable
Lipsync Auto/Manual Select
Adjustment
Dynamic Range
Sound Max Volume
Initial Volume
Adaptive DSP Level
CINEMA DSP 3D Mode
Virtual Surround Back Speaker
Video Video Mode
HDMI Control
HDMI Audio Output
Standby Through
Function
Automatically optimizes the speaker settings (YPAO).
Selects a speaker system.
Front Selects the size of the front speakers.
Center Selects whether or not a center speaker is connected and its size.
Surround Selects whether or not surround speakers are connected and their size.
Surround Back Selects whether or not surround back speakers are connected and their size.
Selects whether or not front presence speakers are connected and their size.
Front Presence
Subwoofer Selects whether or not a subwoofer is connected and its phase.
Layout Selects the layouts of the surround speakers and front presence speakers.
Bass Cross Over Sets the lower limit of the low-frequency component that can be output from speakers whose size is set to "Small".
Sets the distance between each speaker and listening position.
Adjusts the volume of each speaker.
Adjusts the tone with an equalizer.
Enables/disables the test tone output.
Enables/disables the Lipsync adjustment for each input source.
Selects the method to adjust the delay between video and audio output.
Adjusts the delay between video and audio output manually.
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.
Sets the maximum volume to prevent excessive loudness.
Sets the initial volume for when this receiver is turned on.
Selects whether to automatically adjust the CINEMA DSP effect level when the volume is adjusted.
Enables/disables CINEMA DSP 3D.
Selects whether to create Virtual Surround Back Speaker (VSBS) using the surround speakers.
Enables/disables the video signal processing (resolution and aspect ratio).
Enables/disables HDMI Control. You can also configure the relevant settings (such as ARC and TV audio input).
Selects a device to output audio.
Select whether to output videos/audio (input through HDMI jacks) to the TV when the unit is in standby mode.
103
En
Page
32
105
105
105
105
106
106
106
106
106
107
107
107
108
108
108
109
109
109
109
109
109
109
110
111
112
112