Table of Contents
Advertisement
*5:
This mode does not work for about three minutes after the lamp lights. A change in signal may
not be detected depending on the input image. The lamp may become brighter at intervals
during lamp dimming. However, this is not a malfunction. If With No Input is set, it takes
priority.
*6:
Select "Off" to avoid entering standby mode when there is no input signal.
*7:
Does not function when "Type A USB", "Type B USB" or "Network" is selected as the input.
In this case, it becomes equivalent to "Standard."
*8:
Reflecting changes in WLAN settings may take a few moments.
*9:
To set the IP address manually, select "Manual", press "Apply", then enter the IP address.
*10: When you send images or files from a tablet PC/smartphone and display them (page 53), set
"WLAN Network" to "Access Pt." to use the IFU-WLM3 USB wireless LAN module (not
supplied) as a wireless access point.
*11: To change the settings for "Access Pt.," go to the Web page.
For details, see "Setting the WLAN Network of the projector" (page 39).
If "Access Pt." is set, it is more convenient that you set "Display Setting" in "Network
Presentation" of the projector to "AP Mode" (page 31) in advance when you use Presentation
Function via the network (page 46).
*12: To change the "Client" settings, use the Web page for change. For details, see "Setting the
WLAN Network of the projector" (page 39).
*13: Constant Brightness mode will be enabled for about 2,000 hours after it is activated at early
usage. After this period, it will be disabled automatically. Activated time and brightness may
vary depending on the usage conditions.
*14: If the projector cannot connect wirelessly, click [Apply] once again to make sure the
connection is established. For details, see "Setting the WLAN Network of the projector"
(page 39).
*15: If the image output settings of the HDMI device are not appropriate, the bright parts in the
image may become too bright, or the dark ones may become too dark.
*16: The INPUT E terminal is available on VPL-EW348 only.
*17: Do not turn off the projector soon after the lamp lights. It may cause a malfunction of the lamp
(does not light ,etc.).
The Connection/Power Menu
33
Hide quick links:
Advertisement
Table of Contents
