Monster Power PRO 7000 Owner's Manual page 33

LIT_PRO7000_manual.qxd 11/10/2003
Possible Cause #3:
The power cord from the PowerSource is plugged into an outlet on the back of a component that is not turned on.
Possible Solution:
• Turn on the component.
NOTE: For the best possible performance, plug the PowerSource into a wall outlet,
not an outlet on another component.
PROBLEM – The PowerSource is not providing power to connected components.
Possible Cause #1:
The component is plugged into an outlet programmed as SWITCHED ON or SWITCHED ON AFTER DELAY
and the PowerSource has not been turned on.
Possible Solutions:
• Press the ON/OFF button on the PowerSource. The components plugged into its outlets
programmed as SWITCHED ON should turn on immediately.
• Press the ON/OFF button for the components plugged into the PowerSource outlets
programmed as as SWITCHED ON AFTER DELAY to turn on.
• Plug the component into an outlet programmed as UNSWITCHED.
4:30 PM Page 27
TROUBLESHOOTING
26