Monster Power HTPS7000 Owner's Manual page 31

Possible Cause #3:
The PowerSource's power cord is plugged into an outlet on the back of one of your components and the component
is not turned on.
Possible Solution:
• Turn the component on.
NOTE: For the best possible performance, plug the PowerSource into a wall outlet, not an outlet on another
component.
Possible Cause #4
The PowerSource is defective.
Possible Solution:
• Please see page 31 for warranty information.
PROBLEM – PowerSource is not providing power to the components.
Possible Cause #1:
The component is plugged into an outlet programmed as "switched on" or "switched on after delay" and the
PowerSource has not been turned on.
Possible Solutions:
• Press the ON/OFF button on the PowerSource. The components plugged into the PowerSource's outlets
programmed as "switched on" should be turn on immediately.
• Press the ON/OFF button on the PowerSource and wait for a few seconds for the components plugged into
the PowerSource's outlets programmed as "switched on after delay" to be turn on.
OR, plug the component into an outlet programmed as "unswitched".
TROUBLESHOOTING (CONTINUED)
23