Electrical Specification - Sharp 15JF-25S Service Manual

•Power Input .................... 220V-240 Volts AC 50Hz
•Power Consumption
Normal Operation (Method IEC60107) ............ 37W
Stand-by Operation ............................................ 3W
•Audio Power Output Rating ........................ 2 W (MPO)
Speaker .............................. 16
•Convergence ............................... Self Converging System
•Focus ....................... High Bi-Potential Electrostatic
•White Level
Set brightness control to get total picture tube cathode current of 1000 µA under no signal condition.
Maximum necessary correction of each picture tube cathode current to get 8550 degrees K+1 MPCD
screen temperature should not exceed 15% of its original value.
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
ELECTRICAL SPECIFICATIONS
Ω,
4W, 9 x 5 cm, 1pc
X=0.290 ± 0.015
Specifications are subject to change without prior notice.
MODEL DESTINATION (Operation Manual languages)
15JF-25S: Deutsch, Nederlands, Français.
15JF-25SIT: Italiano.
•Sweep Deflection ..................................... Magnetic
•Picture Intermediate frequency ................. 38.9 MHz
•Sound Carrier Trap .................................. 33.4 MHz
•Adjacent Sound Carrier Trap ................... 40.4 MHz
•Adjacent Picture Carrier Trap ................. 31.9 MHz
.
•Aerial Input Impedance
VHF/UHF ...................... 75 ohm Unbalanced
•Tuning Ranges........... 48.25 MHz thru 855.25 MHz
VHF: CH02 - CH12
S1 - S41 (Hiperband)
UHF: CH21 - CH69 CH
Y=0.300 ± 0.015
WARNING
3
15JF-25S