Icom IC-F4261DT Service Manual page 49

3. REMOVING THE JACK UNIT
1) Unsolder 8 points at the dial.
DIAL
VR UNIT
2) Remove a nut and top plate from the chassis,
and then remove the VR UNIT from the chassis.
Chassis
UNSOLDER
Solder
remover
Chassis
VR UNIT
Top plate
(with GPS module)
Nut
3 - 2
4. REMOVING THE RF UNIT
1) Unsolder 4 points as shown.
UNSOLDER
Solder
remover
Chassis
Solder
remover
2) Remove 4 screws from the RF UNIT, and then
remove the RF UNIT from the chassis.
Chassis
RF UNIT
UNSOLDER
Screws
RF UNIT