Installing The Memory Module; Removing The Intrusion Switch; Installing The Intrusion Switch - Dell OptiPlex 7040 Owner's Manual

Installing the memory module

1. Align the notch on the memory module with the tab on the memory module connector.
2. Insert the memory module into the memory module socket.
3. Press the memory module until the memory module retention tabs click into place.
4. Install the:
a. optical drive
b. hard drive assembly
c. fan duct
d. cover
5. Follow the procedure in

Removing the intrusion switch

1. Follow the procedure in
2. Remove the:
a. cover
b. fan duct
3. To remove the intrusion switch:
a. Disconnect the intrusion switch cable from the connector on the system board [1][2].
b. Slide the intrusion switch and lift it away from the computer [3].

Installing the intrusion switch

1. Insert the intrusion switch into the slot on the chassis.
2. Connect the intrusion switch cable to the system board.
3. Install the:
a. fan duct
b. cover
4. Follow the procedure in
After Working Inside Your
Before Working Inside Your
After Working Inside Your
Computer.
Computer.
Computer.
11