Drawer Removal; Light Bulb Replacement - GE 24 Use And Care & Installation Manual

Drawer Removal

Drawers will stop before coming all the way out of the refrigerator to
help prevent contents from spilling onto the floor. Drawers can easily
be removed by tilting up slightly and pulling past the "stop" location.
Remove the door bins from the fresh food door before removing
the drawer.
To remove the shelf above the top
drawer, first remove the top drawer
and any food on the shelf. Then tilt
the shelf up at the front and lift it up
and out of the tracks.
To replace the shelf, raise the
shelf front slightly and place the
top hooks in the lowest large track
slots. Then lower the front of the
shelf until it is level.

Light Bulb Replacement

Fresh Food Compartment–Upper Light
1. Unplug refrigerator.
2. Pull off the temperature control
knobs.
3. Pull bottom of the light shield
down and forward, then rotate
the top up and off.
After replacing with same size
bulb, reinstall the light shield.
12
CARE AND CLEANING
(continued)
When replacing the drawers, make
sure you slide them through both
drawer guides on the right side.
To remove the drawers when the
fresh food compartment door
cannot be opened fully you need to
roll the refrigerator forward until
the door can be fully opened. In
some cases this will require moving
the refrigerator to the left as you roll it out.
Fresh Food Compartment–Two Lower Lights (on some models)
These lights are located behind the top drawer.
1. Unplug the refrigerator and remove the top drawer and cover.
2. Grasp the bottom edge of the shield and pull forward and up to free
3. After replacing with the same size appliance bulb, replace
Freezer Compartment
1. Unplug the refrigerator.
2. Remove the shelf just below light shield. (The shelf
3. Pull the light shield toward you to reach the bulb.
After replacing with same size bulb, reinstall shelf and plug the
refrigerator back in.
its bottom edge.
the shield.
will be easier to remove if it is emptied first.)
Drawer
Guides