Removing The Right (Refrigerator) Door; Reinstalling The Right (Refrigerator) Door; Reinstalling The Left (Freezer) Door - LG LSXS26326 Owner's Manual

14 INSTALLATION

Removing the Right (Refrigerator) Door

wire
harness
1. Open the door. Remove the top hinge cover
screw.
2. Use a flat blade screwdriver to pry back the
hooks (not shown) of the hinge cover from
the top of the refrigerator cabinet. Lift up
the cover. Disconnect all wire harnesses.
upper
hinge
3. Rotate the hinge lever clockwise (1). Lift the
upper hinge free of the hinge lever latch (2).
CAUTION
When lifting the hinge free of the latch, be
careful that the door does not fall forward.
4. Lift the door from the lower hinge pin.
lower hinge
5. Place the door, inside facing up, on a non-
scratching surface.
NOTE
 Do not remove the grease on the sur-
face of the gasket or hinge.
 Do not remove the sensor assembly in
the right upper hinge cover.

Reinstalling the Right (Refrigerator) Door

hinge lever

Reinstalling the Left (Freezer) Door

1. Place the door onto the lower hinge pin.
2. Fit the upper hinge over the hinge lever
latch and into place. Rotate the lever
counterclockwise to secure the hinge.
3. Reconnect all wire harnesses. Hook the tab
on the switch side of the cover under the
edge of the wire opening in the cabinet top.
Position the cover and replace the screw.
1. Feed the water tubes through the lower
hinge pin and place the door onto the
lower hinge pin. Water hoses should be
behind the leg to prevent damage.
2. Fit the top hinge over hinge lever latch and
into place. Rotate the lever clockwise to
secure the hinge.
3. Install the grounding screw and connect all
the wire harnesses.
4. Hook the tab on the door switch side of the
cover under the edge of the wire opening
in the cabinet top. Position the cover into
place. Insert and tighten the cover screw.
5. Reconnect the water tubes by inserting
the tubes into the connectors. The tube is
inserted correctly when only one guide line
is showing out of two.
Collet
Tube
Insert Line
NOTE
 Water hoses should be cut with a
clean, straight edge to avoid leaks.
Not Straight Damaged Stretched