Husqvarna Viking Designer I Service Manual page 21

Settings
Adjustment
Get into the service program of the machine.
The needle should be in its highest position.
Touch Needle - , row 1.
Loosen screw (E) in the cog wheel (D) on the step motor shaft.
Turn the cog wheel until the needle is in the centre of
the presser foot.
Touch Needle - , row 1 .
Loosen screw (F) in the calibration stop (G) and
turn it until the gap is correct (0mm).
Note! The position of the eccentric.
Touch Needle - , row 1 .
Turn the screw (H) until the gap is correct (0 mm).
This setting is only a sideways limitation.
Touch Needle - , row 1
The needle should now take its centre position into the needle
hole of the presser foot.
104 72 47-26
21