Local Area Network Setup - Bunker Hill Security 61229 Owner's Manual & Safety Instructions

local area network (lan) Setup
Read the EntiRE imPORtant SaFEtY inFORmatiOn section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
note: This setup allows you to connect to the DVR through the Internet within your home network.
This setup requires the use of a Windows ® PC (sold separately) with Internet Explorer ® ,
an Ethernet Cable (sold separately) and a Router (sold separately).
network > network
Use the chart below to record the information you will need to set up your LAN.
Subnet mask
Default Gateway (Router's iP address)
new DVR iP address
DVR's lan address
Figure aO
1. Connect DVR to Router via Ethernet Cable.
2. On PC, go to Start menu, then click Run.
a. Type "cmd" then click Ok. A
DOS window will open.
b. Type "ipconfig" then press Enter.
c. You will see the Local Area
Connection of the Router.
d. In the chart above, write down the
numbers corresponding to:
• Subnet Mask
• Default Gateway (Router's IP Address).
3. Create a new DVR iP address:
a. If last 3 digits of Default Gateway
are 0-99, change last 3 digits to a
number between 100 and 255.
b. If last 3 digits of Default Gateway are
100 or more, change last 3 digits to a
number between 200 and 255.
c. new DVR iP address will be xxx.xxx.xxx.yyy
where x = first 3 sets of current Default
Gateway (Router's IP Address) and
y = new set created in 3.a. or b.
Page 28
Figure an
For technical questions, please call 1-800-444-3353.
d. Write the new DVR iP address
in the chart above.
4. On DVR, go to network > network:
a. Change type to Static.
b. Change Client Port to 3000.
c. Change httP Port to 3001.
d. Change iP address to the new DVR
iP address from the chart.
e. Change Subnet mask and (Default)
Gateway to the ones from the chart.
f. Change DnS1 to be the same as Gateway.
g. Click apply, then Exit. DVR will
prompt restart. Click Ok.
5. After restart, go back to network >
network to view the settings.
6. Open Internet Explorer ® and type in the iP
address and httP Port in the address bar:
a. http://xxx.xxx.xxx.xxx:3001
where x = iP address and 3001 = httP Port.
Write this address on chart under
DVR's lan address.
b. Press Enter.
c. Allow ActiveX control to install.
note: You my need to adjust the settings in
Internet Explorer ® by adding the http address to
Trusted Sites and modifying ActiveX controls.
7. After ActiveX Control installs, Log in to DVR
using User DVR's user name and Password.
8. The DVR can now be controlled by a
computer in your home network.
Item 61229