Specifications - Stihl TS 400 Cutquick Instruction Manual

English / USA

Specifications

EPA / CEPA:
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category:
A = 300 hours,
B = 125 hours,
C = 50 hours
CARB:
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours,
Intermediate = 125 hours,
Moderate = 50 hours
46
Engine
STIHL single cylinder two-stroke engine
Displacement:
Bore:
Stroke:
Maximum spindle speed:
(make sure that the
maximum operating
wheel speed is above or
equal to the maximum
spindle speed of your
cut-off machine)
Ignition System
Type: Electronic magneto ignition
Spark plug (suppressed):
Bosch WSR 6 F or NGK BPMR 7 A
Electrode gap
0.02 in (0,5 mm)
Carburetor
All position diaphragm carburetor with
integral fuel pump
Starter system
ElastoStart starter rope
dia. 0.18 in (4.5 mm)
1122 190 2900
Fuel tank capacity
1.39 pt (0,66 l)
Abrasive wheels
Composite abrasive wheels for steel,
stone, asphalt, ductile cast pipes and
3.9 cu.in
1)
plastics .
3
(64,1 cm )
Diamond abrasive wheels for stone and
1.93 in
asphalt.
(49 mm)
Dia. 12 in (300 mm) or 14 in (350 mm)
1.34 in 0.10 to 0.24 in (2.6 to 6 mm) thick
(34 mm)
Arbor hole diameter, spindle
5350 rpm
diameter
0.787 in (20 mm)
Min. thrust washer diameter
4.1 in (103 mm)
Cutting depth with thrust plate
dia. 4.1 in (103 mm):
3.9 in (98,5 mm) for dia. 12 in (300 mm)
4.9 in (123,5 mm) for dia. 14 in (350 mm)
1)
Not available in all countries
TS 400