THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
: internal component.
¢
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• C : panel designation.
Note:
Note:
The components identi-
Les composants identifiés par
fied by mark ! or dotted
une marque ! sont critiques
line with mark ! are criti-
pour la sécurité.
cal for safety.
Ne les remplacer que par une
piéce por tant le numéro
Replace only with part
spécifié.
number specified.
• U : B+ Line.
• V : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground in
playback mode.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Abbreviation
CND : Canadian model.
AUS : Australian model.
CH
: Chinese model.
For printed wiring boards.
Note:
• X : parts extracted from the component side
•
: Through hole.
®
•
: internal component.
¢
• b : Pattern of the rear side.
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B)
pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A)
parts face are indicated.
• Indication of transistor
C
Q
These are omitted
B
C
E
B
E
These are omitted
WAVEFORMS
– DIGITAL (1/8) SECTION –
1
6.2 Vp-p
12 MHz
IC1004 !∞
2
6 Vp-p
3.3 µsec
IC1004 !¡
3
5 Vp-p
48 KHz
IC1004 0
4
5.2 Vp-p
IC1015 3
5
5 Vp-p
IC1015 5
– 41 –
– DIGITAL (2/8) SECTION –
– DIGITAL (4/8) SECTION –
1
1
5.5 Vp-p
1.2 µsec
IC2015 7
2
2
5 Vp-p
75 µsec
IC2015 !¢
3
3
5.8 Vp-p
0.3 µsec
IC2015 !§
4
– DIGITAL (6/8) SECTION –
5.6 Vp-p
1
6 µsec
IC2015 !•
5
5 Vp-p
2
75 µsec
IC2015 !ª
6
5 Vp-p
– DIGITAL (7/8) SECTION –
1.2 µsec
1
IC2015 $™
7
5.5 Vp-p
3 µsec
2
IC2015 #•
3
4
TA-E9000ES
– DISPLAY SECTION –
1
4.8 Vp-p
0.8 µsec
20 MHz
IC2005 (ª
IC901 2
2
3.3 Vp-p
150 µsec
4 µsec
IC2005 `⁄‚·
IC901 9
3.3 Vp-p
2.3 µsec
IC2005 `⁄⁄‚
4.4 Vp-p
20 MHz
IC3008 2
4.2 Vp-p
7.28 MHz
IC3002 !§
3.8 Vp-p
0.8 µsec
IC4001 %¢
3.5 Vp-p
3.6 µsec
IC4001 %£
3.2 Vp-p
22.5 µsec
IC4001 %™
4 Vp-p
24.576 MHz
IC4002 $º
– 42 –
4.6 Vp-p
4.8 Vp-p