Advertisement
4 Test Mode
4.1.
Test mode
4.1.1.
Test mode activation
Activation mode
The test mode activation can be done if the dishwasher is at the beginning status with empty chamber. To do this it is enough to
recall the "program cancellation" mode described at point 2.2. The test mode is then recalled as following described:
1. Open the door, press and keep the P button pressed. After 5 seconds, the "cycle cancellation" is shown on the display as fol-
low:
2. Keep the P button pressed till the program warning lights are as follow:
3. Release and then immediately press the P button. The buzzer gives out an acoustic signal and all the warning lights switch on
and the program lights are shown as follow:
If the test mode procedure is not correctly done , it is necessary to repeat the procedure from the point (1).
12
Hide quick links:
Advertisement
