Auto-Control Interface And Directions; Ddc Adjustment Command Set - LG 42PJ350R Service Manual

* Auto-control interface and directions

(1) Adjust in the place where the influx of light like floodlight
around is blocked. (Illumination is less than 10ux).
(2) Measure and adjust after sticking the Color Analyzer (CA-
100+, CA210 ) to the side of the module.
(3) Aging time
- After aging start, keep the Power on (no suspension of
power supply) and heat-run over 5 minutes
*Above optical characteristics are should be measured by
following condition.
Picture Mode
Fresh Contrast
Fresh Color
Smart Power Saving

DDC Adjustment Command Set

O
Copyright ©2010 LG Electronics Inc. All rights reserved.
Only for training and service purposes
Measured Mode
Vivid
Off
Off
Off
Adjustment
Adjustment
Adjustment
- 14 - LGE Internal Use Only