Bosch SHI 4302 Troubleshooting Tips page 28

Page F-1B
SHI/U 43/53/68 Dishwasher Test Programs
TEST*
Draining
Aqua Sensor
Calibration
("Sensotronic")
Filling
Heating & Circulating
Draining
* To skip a test:
SHU 4322 & 4326 MODELS
To start test program, press and hold both REGULAR WASH and RINSE & HOLD program buttons, then turn unit on by
pressing ON/OFF button. Initially, control module version # will be displayed (e.g./ "20" = version 0 without jumper). When
wash program buttons are released, lights above them will flash. To end test program, press ON/OFF button.
To check each program indicator light, press its button. To check Cycle Countdown display, Refill Rinse Agent light and
REGULAR WASH light, press REGULAR WASH button (press Delay Start button to test Cycle Countdown display
alone). Cycle Countdown display will show "88" when REGULAR WASH button is pressed and "8h" when Delay Start
button is pressed.
To start testing, press both the REGULAR WASH and RINSE & HOLD buttons a second time. When testing has ended,
Cycle Countdown display will show a fault using codes below. If more than one fault occurs, code numbers will be added
together, (e.g./ "6" = faults 2 + 4).
0 = No faults detected
1 = Aqua Sensor ("Sensotronic") fault
To check for heater, high limit or flow switch problems, start testing until heating starts. Using a meter with a current coil,
measure current going into dishwasher. If current is ~ 11 A, then heater, high limit and flow switch are OK. If current stays
at ~ 1.5-2 A, then heater, high limit or flow switch are faulty.
If water level switch (f 1 ) has failed (opened), display will show fault code "4" and unit will continually fill and drain where
testing won't be completed. If flow switch (e 5 ) has failed (opened), display will show "0", water won't heat (to 150
water won't stop circulating. If NTC probe (f 2 / f 4 ) has failed (opened), display will show fault code "8" immediately and
testing will end shortly after water has started circulating.
SHU 4322/4326 models program buttons & indicator lights:
See page F-
1A for SHI/U
43 models, F-
1C for SHU
53 models
and page F-
1D for SHI/U
68 models
st
1 Edition/Revision 2
30 seconds
65 seconds
Until Water Level Switch (f1) closes
Until water temperature reaches 150
60 seconds
SHI/U 43 models
SHI/U 53/ 68 models
2 = Heating fault
4 = Filling fault
Cycle Countdown Power
Scrub
Plus
20
¢ ¢ ¢ ¢
TIME
º º
F (65 C)
8 = NTC (temperature sensor) fault
F = Filling fault (display occurs during wash, not test)
Regular Delicate
/Econo
Wash
¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢
l l l l
Cancel
Drain
NOTES
Not on SHI/U 43-- models
Can't skip this test
Dispenser actuator comes on
Press SCRUB WASH button.
Press REGULAR WASH button.
Rinse Refill
Rinse
& Hold
Agent
¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢
l l l l
Tuesday, June 27, 2000
B
º
F) and