Sharp LC-20D30U Service Manual page 40

LC-20D30U
5. On Setting Items
* "EZ-SETUP" discussed below indicates "EZ-SETUP after the first power-on".
(1) MAXIMUM VOLUME
Selection Adjustment from 1 to 60 (no loop)
Default 60
Explanation Sound volume can not be adjusted higher than the preset value.
Limit in Setting » When the sound volume is set lower than 59, only figures are displayed and the sound volume bar is not
displayed.
The maximum sound volume for ON-timer (Wake up timer) is limited also to the preset value.
»
Exception » In the item
setting.
Remarks Setting is valid only for the speakers of the unit. (As for the headphone, the sound volume can be set up
»
to 60 irrespective of the limit.)
» In line output (sound volume variable), the sound volume can be adjusted from -60 to 0 irrespective of
pre-adjusted value.
When the sound volume is set higher than the MAX setting by the adjusting process or headphone, the
»
sound volume control operation is prohibited for turn-up and the sound volume should be turned down to
MAX in this state.
(2) VOLUME FIXED
Selection Selection between
Default Variable
Explanation Sound volume is fixed and made invariable.
Limit in Setting » The sound volume for the ON-timer (Wake up timer) is fixed also without display of menu. Besides, the
setting is made impossible. (Basically, the menu is not displayed.)
The following keys become invalid:
»
» Sound volume Up/Down (VOL +/-) [for both remote control and the unit]
» Mute (MUTE)
Exception In the item
»
setting.
"
Remarks » In
abolished (and follows the last memory).
The sound volume for the ON-time is not set at 1 either and the sound volume set value of the ON-timer
»
before executing the hotel mode is held.
» Setting is valid only for the speakers of the unit. (As for the headphone, the sound volume can be set up
to 60 irrespective of the limit.)
In line output (sound volume variable), the sound volume can be adjusted from -60 to 0 irrespective of
»
pre-adjusted value.
» As for sound volume fixing and sound volume MAX level, the sound volume fixing has priority.
Once the sound volume has been changed by adjustment process or headphone, it should be set back to
»
the sound volume preset by sound volume fixing level when the adjustment process ends or when the
headphone is removed.
" "
VOLUME of adjustment process, the sound volume can be set freely irrespective of this
"Variable" and "Fixed" (loop provided)
" "
VOLUME of adjustment process, the sound volume can be set freely irrespective of this
"
Variable setting, the sound volume had been conventionally set at 1 but this operation has been
40