Autofocus Adjustment; Stabilizer Adjustment; Spot Noise Adjustment - Hitachi VM-H675LA Service Manual

4.2 Autofocus Adjustment

ERROR MESSAGE
TIME OUT ERROR ON FOCUS
TIME OUT ERROR ON ZOOM
TIME OUT ERROR ON AF STEP
AF LIMIT OVER
AF ERROR
TOO DARK

4.3 Stabilizer Adjustment

ERROR MESSAGE
THIS MODEL NEED NOT BE ADJUSTED
PRESS ANY KEY.
INVALID MODEL
PRESS ANY KEY

4.4 Spot Noise Adjustment

ERROR MESSAGE
ERROR!!
SPOT NOISE COMPENSATION IS
STOPPED BY INITIAL DATA.
PLEASE CHECK THE EEPROM.
PRESS ANY KEY.
ERROR!!
THRESHOLD DATA ERROR.
PLEASE CHECK THE EEPROM.
PRESS ANY KEY.
ERROR!!
THE SPOT NOISE IS TOO MANY.
CAN'T COMPENSATE ANY MORE.
PRESS ANY KEY.
COUNTERMEASURE
Check the conditions of subject.
If this error message appears even when the adjustment is
performed 2 or 3 times, the autofocus circuit system is defective.
Refer to (1) of TROUBLESHOOTING OF AUTOFOCUS.
If this error message appears even when the adjustment is
performed 2 or 3 times, the autofocus circuit system is defective.
Refer to (2) of TROUBLESHOOTING OF AUTOFOCUS.
Check the conditions of subject.
If this error message appears even when the adjustment is
performed 2 or 3 times, the autofocus circuit system is defective.
Refer to (1) of TROUBLESHOOTING OF AUTOFOCUS.
Check the conditions of subject.
If this error message appears even when the adjustment is
performed 2 or 3 times, the autofocus circuit system is defective.
Refer to (2) of TROUBLESHOOTING OF AUTOFOCUS.
If this error message appears even when the adjustment is
performed 2 or 3 times, the autofocus circuit system is defective.
Refer to (1) of TROUBLESHOOTING OF AUTOFOCUS.
Insufficient lighting. Check the subject.
COUNTERMEASURE
Adjustment is to be started for models that do not need adjustment.
Model selection is incorrect.
Initial setting for each model is incorrect.
Make sure of model selection and initial setting for each model.
(If they are incorrect, readjust all adjustment items.)
Adjustment is to be started for models that do not need adjustment
(or adjustment is inappropriate).
Model selection is incorrect.
Initial setting for each model is incorrect.
Make sure of model selection and initial setting for each model.
(If they are incorrect, readjust all adjustment items.)
COUNTERMEASURE
Spot noise compensation is inhibited by the data in the
EEPROM.
Turn the power on again.
Data in the EEPROM is defective. (Initialize it.)
Check the EEPROM,and if necessary,replace it.
Turn the power on again.
Data in the EEPROM is defective. (Initialize it.)
Check the EEPROM,and if necessary,replace it.
The amount of spot noise that can be compensated reaches the
limit.
Turn the power on again.
Check the CCD image sensor,and if necessary,replace it.
3 - 13