Table of Contents
Advertisement
Note
• The bobbin case (gray) cannot be used for sewing in
any way other than bobbin work. After sewing
bobbin work, refer back to the steps in "Preparing
the Bobbin Thread" for removing and cleaning the
bobbin case (gray), and then reinstall the standard
bobbin case (black).
• Be sure to use the bobbin case (gray) when creating
bobbin work. Using any other bobbin case may
result in the thread becoming tangled or damage to
the machine.
• Make sure that the bobbin case is correctly
installed. If the bobbin case is incorrectly installed,
the thread may become tangled or the machine may
be damaged.
h
Wind a decorative thread around the bobbin
by hand. After winding the bobbin so it is
filled as shown below (about 80%), cut the
thread.
• Be sure to use the machine's included bobbin or one
designed specifically for this machine. Using any
other bobbin may result in damage or injuries.
11.5 mm
(approx.
7/16 inch)
Note
• Slowly and evenly wind the thread around the
bobbin.
• For best results, wind the bobbin so the thread is
snug and not twisted.
30
CAUTION
CAUTION
Actual size
This model
Other models
i
Using scissors carefully trim the thread tail as
close to the bobbin as possible.
a
Beginning of wound thread
CAUTION
• If thread extends beyond the top of the bobbin too
much, the thread may become tangled or the
needle may break.
j
Install the bobbin wound with thread.
Whether or not tension should be applied to the
bobbin thread depends on the type of thread
being used.
Advertisement
Table of Contents
