California Energy Commission Battery Charging Testing Instructions - AT&T TL86009 User Manual

Appendix
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the
box. These instructions are intended for California Energy Commission (CEC) compliance
testing only. When the CEC battery charging testing mode is activated, all telephone
functions on the cordless handsets, except battery charging, will be disabled.
When first purchased and properly installed for charging (see Battery installation and
charging on pages 6-7), put the handset in the handset charger to charge. The CEC
battery charging testing mode is activated while charging.
If you have registered the handset to the TL86109 base, below are the testing
instructions.
To activate the CEC battery charging testing mode:
1. When the phone is not in use, press and hold FLASH on the telephone base for about
4 seconds until it shows Deregister all handsets?. Then, release the button.
2. Press the YES softkey to continue. You hear a confirmation tone from the telephone
base.
3. The telephone base displays PLEASE WAIT.... All system handsets show Out of range
OR no power at base for a few seconds, and then you hear a confirmation tone from
the handset.
When the phone successfully enters the CEC battery charging testing mode, all
handsets show Press [HOLD] on base for 4 sec, then press [#] on handset.
When the phone fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See page 11 for handset
registration instructions.
33
BC