Figure 6-4: Site Map - Linksys RV082 User Manual

10/100 8-Port VPN Router
Port Statistics
Users can click the port number from the port diagram to see the status of the selected port. If the port is
disabled, it will be red; if enabled, it will be black; if connected, it will be green. In the summary table, it will show
the setting of the port selected by users, such as Type, Link Status (up or down), Port Disable (on or off), Priority
(High or Normal), Speed Status (10Mbps or 100Mbps), Duplex Status (half or full), Auto negotiation (enable or
disable). In the statistics table, it will show the port receive/transmit packet count/packet byte count and Port
Packet Error Count of the selected port. The LAN ports can be configured from the LAN Setup page of the LAN
Management Tab.
Network Setting Status
LAN IP: It shows the current LAN IP Address of the Router, as seen by internal users on the network, and
hyperlinks to the LAN Setting section on the Network page of the Setup Tab.
WAN1 IP: It shows the current WAN1 IP Address of the Router, as seen by external users on the Internet and

Figure 6-4: Site Map

hyperlinks to WAN Connection type section on the Network page of the Setup Tab. When users select Obtain an IP
automatically, it shows two buttons, Release and Renew. Users can click the Release button to release the IP that
users already have and click the Renew button to update the DHCP Lease Time or get a new IP. When users
select PPPoE or PPTP, it shows Connect / Disconnect.
WAN2/DMZ IP: It shows the current WAN2 IP Address of the Router, or DMZ IP when DMZ is selected, as seen by
external users on the Internet and hyperlinks to WAN Connection type on the Network page of the Setup Tab.
Mode: It shows the Working Mode (Gateway or Router) and hyperlinks to Dynamic Routing section on the
Advanced Routing page of the Setup Tab.
DNS: It shows all DNS Server Addresses and hyperlinks to WAN Connection Type on the Network page of the
Setup Tab.
DDNS: It shows the status (On/Off) and hyperlinks to DDNS page of the Setup Tab.
DMZ Host: It shows DMZ Private Address and hyperlinks to DMZ Host page of the Setup Tab. The default is
disabled.
Firewall Setting Status
SPI (Stateful Packet Inspection): It shows the status (On/Off) and hyperlinks to the General page of the Firewall
Tab.
DoS (Denial of Service): It shows the status (On/Off) and hyperlinks to the General page of the Firewall Tab.
Chapter 6: Set Up and Configure the Router 19
System Summary Tab