Sanyo PLC-XU301 Owner's Manual page 162

Description of warning value
Warning Column
Un-connected
Connect Connected *
Acquisition error
Power failure
TemperatureError
Normal (AfterTempError)
RS232CFailure
Power status
Power management
LampFailure
Normal(Standby) *
Normal(OnCoolingDown) *
SignalsInterrupted
Input signal status
SignalsInputted *
Inside Temperature status (A to
C] Abnormal
External Temperature status
ON *
Lamp status Failure
Replace
Lamp time (lamp time)
Filter time (filter time)
(Auto play error) Error
The column order and width of the event log window are saved to the registry of the computer.
Up to 1000 of events can be stored. If it exceeds 1000 events, the oldest event is deleted and the
latest event is added. The event log can be saved to the management file.
This Warning column is not available for some projector's model types.
Description of Event, Type, Warning column, Warning value
Warning Value
Projector has been disconnected from the network
Projector has been connected to the network
PJ Network Manager could not acquire the MIB information
from the equipment
Projector turned off due to the power failure of the projector
The projector turned off due to temperature error occurred
Normal after temperature error occurred
The RS-232C communication error occurred
The power management function turned projector lamp off
The lamp failure occurred
Projector turned into standby normally
On cooling down normally due to projector turned off
The signal was interrupted
The signal was inputted again
The projector turned off when the temperature was
abnormally high
When the lamp is on
When the lamp failed to ignite.
It reached lamp replacing time.
It reached user setting lamp replacing time
It reached user setting filter time
The error occurred during the auto image display
The warning value with "*" in the above table shows the
event when the alert has cleared, alert type is "OFF".
Description
PJ NETWORK MANAGER
OWNER'S MANUAL
25