Initial Settings - Panasonic Lumix DMC-FX37P Service Manual

3.4.2.

INITIAL SETTINGS:

When you replace the MAIN PCB, be sure to perform the initial settings after achieving the adjustment by ordering the following pro-
cedure in accordance with model suffix of the unit.
1. IMPORTANT NOTICE:
Before proceeding Initial settings, be sure to read the following CAUTIONS.
2. PROCEDURES:
• Precautions: Proceed the picture back up from the unit. (Refer to above "CAUTION 2")
• Preparation. Set the Mode dial to "Normal Picture Mode" (Red camera mark).
• Step 1. The temporary cancellation of initial setting:
Set the [REC]/[PLAYBACK] selector switch to "[ REC ] (Red camera mark)".
While keep pressing [ DISPLAY ] and "[ UP ] of Cursor buttons" simultaneously, turn the Power on.
• Step 2. The cancellation of initial setting:
Set the [REC]/[PLAYBACK] selector switch to "[ PLAYBACK ]".
Press [ DISPLAY ] and "[ UP ] of Cursor buttons" simultaneously, then turn the Power off.
• Step 3. Turn the Power on:
Set the [REC]/[PLAYBACK] selector switch to "[ REC ] (Red camera mark)", and then turn the Power on.
• Step 4. Display the INITIAL SETTING:
While keep pressing [ MENU/SET ] and "[ RIGHT ] of Cursor buttons" simultaneously, turn the Power off.
When MAIN P.C.B. is replaced, all of the model suffix is displayed as follows.
There are two kinds of "INITIAL SETTINGS" menu format.
[1. After replacing MAIN P.C.B.]
10