Daewoo 432X Service Manual page 7

IC Removal/Replacement
Some utilized chassis circuit boards have slotted (oblong) holes through which the IC leads are inserted and
then bent flat against the circuit foil. When holes are slotted, the following technique should be used to remove
and replace the IC. When working with boards using the familiar round hole, use the standard technique as
outlined in paragraphs 5 on the page under the title of general soldering guidelines.
Removal
1. Desolder and straighten each IC lead in one operation by gently prying up on the lead with the soldering iron
tip as the solder melts.
2. Draw away the melted solder with an anti-static suction-type solder removal device (or with desoldering braid
before removing the IC.
Replacement
1. Carefully insert the replacement IC in the circuit board.
2. Carefully bend each IC lead against the circuit foil pad and solder it.
3. Clean the soldered areas with a small wire-bristle brush. (lt is not necessary to reapply acrylic coating to the
area).
"Small-Signal" Discrete Transistor Removal/Replacement
1. Remove the defective transistor by clipping its leads as close as possible to the component body.
2. Bend the end of each of three leads remaining on the circuit board into a "U" shape.
3. Bend the replacement transistor leads into a "U" shape.
4. Connect the replacement transistor leads to the corresponding leads extending from the circuit board and
crimp the "U" with long nose pliers to insoure metal-to-metal contact, then solder each connection.
FIGURE 1. USE SOLDERING IRON TO PRY LEADS
5