Error Code/Message - Panasonic CF-30 series Operating Instructions Manual

Error Code/Message

Follow the instructions below when an error message or code appears. If the problem persists or if the error code/mes-
sage is not shown here, contact Panasonic Technical Support.
Error Code/Message
0211 Keyboard error
0251 System CMOS
checksum bad -
Default confi guration
used
0271 Check date and
time settings
0280 Previous boot
incomplete - Default
confi guration used
Press <F2> to Setup
*1
0613: Serial Port con-
fi guration changed
*1
0614: Serial Port
confi g. error - device
disabled
*1
"A" or "B" appears
here to indicate the
name of the confl ict-
ing port.
Operating System not
found
RAM Module Failed
To start the Setup Utility
A Restart the computer.
B Press F2 several times while [Panasonic] boot screen is displayed.
24
Disconnect external keyboard or mouse.
An error has occurred in the memory of Setup Utility settings. This occurs when the memory
content is changed by an unexpected program operation, etc.
Start the Setup Utility and return the settings to the default values, and then change the
settings as necessary.
If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support.
The date and time settings are not correct.
Start the Setup Utility and set the correct date and time.
If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support.
Startup has failed repeatedly, so the Setup Utility settings have been returned to the default
values to startup the computer.
Start the Setup Utility and return the settings to the default values, and then change the
settings as necessary.
Write down the error details and press F2 to start the Setup Utility. Change the settings
if necessary.
The I/O and IRQ settings of the serial ports are in confl ict.
Run the Setup Utility and in the [Advanced] menu, change the port's settings so there is
no confl ict.
The operating system is not installed in the fl oppy disk or the hard disk that you are going to
boot from.
If using a fl oppy disk, change the disk to the one you can use for boot.
If using the hard disk, check if the hard disk is recognized in [Information] menu of the
Setup Utility. If the hard disk is recognized, perform the reinstallation (
contact Panasonic Technical Support.
If a device is connected to the USB port, disconnect the device, or set [USB Port] or
[Legacy USB Support] to [Disable] in the [Advanced] menu of the Setup Utility.
If a device is connected to the ExpressCard slot, disconnect the device, or set
[ExpressCard slot] to [Disable] in the [Advanced] menu of the Setup Utility.
When the RAM module is not inserted correctly or the RAM module is not conforming to the
computer's specifi cations, a beep will sound and the "RAM Module Failed" message will be
displayed when you turn the power on.
Slide the power switch for four seconds or longer to turn off the computer, confi rm that
the RAM module conforms to the specifi cations, and reinsert it.
Solution
page 22). If not,