Use - Metabo W 8-115 Operating Instructions Manual

17026938_1009 kl WS W 8_115 ff NAFTA Protect.book Seite 11 Mittwoch, 21. Oktober 2009 4:34 16
Releasing the "Quick" clamping nut (1):
The "Quick" clamping nut (1) must be
attached before the spindle locking button
(4) can hold the spindle!
- The machine continues to run after switching off.
- Press in the spindle locking button (4) just before
the grinding wheel stops. The "Quick" clamping
nut (1) is released.
7.4 Securing/Releasing the clamping nut
(depending on features): For Type 1 cut-
off wheels OR Type 27 grinding wheels
Securing the clamping nut (13):
The 2 sides of the clamping nut are different.
Screw the clamping nut onto the spindle as
follows:
A
13
B
13
B
13
12
- For wheels thinner than 3/16" turn clamping nut
(13) onto the spindle with the raised collar away
from the wheel so that the wheel can be clamped
securely. Tighten securely using 2-hole spanner
(14).
- For wheels 3/16" and thicker, turn clamping nut
(13) onto spindle with the raised collar facing the
wheel so that the collar engages the ID of the
wheel. Tighten securely using 2-hole spanner
(14).
Releasing the clamping nut:
- Lock the spindle (see chapter 7.1). Turn the
clamping nut (13) anticlockwise using the 2-hole
spanner (14) to unscrew.

8 Use

8.1 Adjusting the speed
(depending on features)
Set the recommended speed at the setting
wheel (7).
Parting grinder and roughing discs, cup wheel,
diamond parting wheel: high speed
Brush: medium speed
Grinding wheel: low to medium speed
8.2 Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When
switching the machine on and off, keep it away
from dust deposits. After switching off the
machine, only place it down when the motor has
come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from the
mains socket or if there has been a power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand in a
safe position and concentrate.
Machines with slide switch:
5
I
Switching on: Push the slide switch (5) forward.
For continuous activation, now tilt down-
wards until it engages.
Switching off: Press the rear end of the slide
switch (5) and release.
Machines with "Protect Paddle Switch" (with
dead man function):
(machines with the designation WP..., WEP...)
0
Switching on: Slide the switch-on lock (8) in
the direction of the arrow and press
the trigger (9).
Switching off: Release the trigger (9).
ENGLISH
ENG
0
8 9 8 9
I
11