Related Manuals for Omega OG60XA
Summary of Contents for Omega OG60XA
- Page 1 INSTALLATION & OPERATING INSTRUCTIONS GAS HOBS MODELS OG60XA, OG61XA, OG62XA, OG63XA, OG64XA, OG67XA, OG72XA, OG90XA, OG91XA, OG92XA...
-
Page 2: Table Of Contents
CONTENTS INSTRUCTIONS FOR SAFE AND PROPER USE POSITIONING OF THE HOB GAS CONNECTION ELECTRICAL CONNECTION ADAPTI ON TO DIFFERENT TYPES OF GAS CLEANING AND MAINTENANCE WARRANTY Thank you for choosing our product. We advise you to read this manual carefully. It contains all the necessary instructions for maintaining the appearance and functional qualities of the hob. -
Page 3: Instructions For Safe And Proper Use
INTRODUCTION INSTRUCTIONS FOR SAFE AND PROPER USE This manual is an integral part of the appliance and therefore MUST be kept in its entirety and in an accessible place for the whole working life of the cooking hob. We advise reading this manual and all the instructions therein before using the cooking hob. - Page 4 INTRODUCTION DO NOT PUT pans without perfectly smooth and flat bottoms on the cooking hob grids. DO NOT USE kitchenware or griddle plates that extend beyond the external perimeter of the hob. THE HOB IS TO BE USED BY ADULTS ONLY. Do not let unsupervised children play with the hob.
- Page 5 INTRODUCTION MARKINGS: include the following: Gas Type Label: fixed to the underside of the appliance. Data plate: fixed to the underside of the appliance stating Model (ii) Number, AGA or SAI-GLOBAL Approval Number, Gas operating pressure, Nominal Gas Consumption etc. AGA or SAI-GLOBAL label fixed to the underside: showing that the (iii) appliance conforms to the Standards.
-
Page 6: Positioning Of The Hob
Natural gas: The regulator supplied MUST be fitted to the thread on the ½” elbow at the rear of the hot plate. The NG regulator MUST be checked and adjusted to 1.0k Pa after installation. ULPG: Can be connected directly with the inlet fitting. The pressure MUST be checked to ensure the supply to the appliance is operating at 2.75kPa. - Page 7 FIGURE 2. Clearance above and around domestic cookers Extract from AS5601 Overhead clearances - (Measurement A) Range hoods and exhaust fans shall be installed in accordance with the manufacturer's instructions. However, in no case shall the clearance between the highest part of the hob of the cooking appliance and a range hood be less than 600mm or, for an overhead exhaust fan, 650mm.
- Page 8 Side clearances - (Measurements B & C) Where B, measured from the periphery of the nearest burner to any vertical combustible surface, is less than 200mm, the surface shall be protected in accordance with Clause 5.12.1.2. to a height C of not less than 150mm above the hob for the full dimension (width or depth) of the cooking surface area.
-
Page 9: Gas Connection
GAS CONNECTION This appliances is suitable for installation with Natural Gas or ULPG Refer to page 11 for the relevant burner pressure and appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulator supplied must be fitted to the gas inlet. -
Page 10: Electrical Connection
WARNING -ALL APPLIANCES MUST BE EARTHED: Omega Appliances cannot accept responsibility for any damage to persons or to property arising from faulty connection or non- connection to earth. Before connecting, installing or servicing the hob, the plug should be removed from the power outlet. -
Page 11: Adapti On To Different Types Of Gas
Replacement injectors are supplied with the appliance or they are available from Omega Appliances or it's agents. All such work MUST be carried out by an Authorized Person. Isolate the electrical supply from the appliance. - Page 12 FIGURE 4 & 5 ig. 5 NOMINAL GAS CONSUMPTI ON Gas Type; Natural Gas MJ/h - NG Burner Injector size mm (1.00 kPa) Small Medium 1.15 Large 1.55 10.8 1.75 13.2 Fish 1.55 10.8 ULPG MJ/h - NG Burner Injector size mm (2.75 kPa) 0.55 Small...
-
Page 13: Cleaning And Maintenance
MAINTENANCE AND CARE: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.