Mitsubishi Electric WD-57733 Owner's Manual page 72

72
Appendices
Appendix E: Troubleshooting, continued
Reset Name When to Use
Front-Panel Lock
To re-enable the front-
Release
panel controls after
activation of the Front-
Panel Lock
System Reset If the TV does not turn on
or off, does not respond
to the remote control or
front panel buttons, or
has audio but no video.
TV Reset To reset all consumer-
IMPORTANT:
accessible settings
Use this reset and all memories to the
only if all other original factory defaults.
resets have been
CAUTION: All owner-
unsuccessful.
performed setups and
adjustments will be
erased.
Service and Support
Service
If you are unable to correct a problem with your TV,
consult your Mitsubishi dealer or Mitsubishi Con-
sumer Relations at (800) 332-2119.
• DO NOT adjust any controls other than those
described in this Owner's Guide.
• DO NOT remove the protective back cover of
your TV.
Support
• To order replacement or additional remote con-
trols, lamp cartridges, or Owner's Guides, visit our
How to Use
• When Energy Mode is set to Fast
Power On, press and hold the MENU
button on the front panel for over
eight seconds.
• When Energy Mode is set to Low
Power, press POWER on the front
panel to turn on the TV. Press and
hold the MENU button on the front
panel for over eight seconds.
Press the SYSTEM RESET button on the front
panel with a pointed object such as the
point of pencil or end tip of a paperclip.
1. While viewing the TV, press MENU to
Main
display the TV menu.
Main
2. With the menu displayed,
press number keys 1 2 3 to display
Reset
the menu.
3. READ THE ON-SCREEN
WARNING AND INSTRUCTIONS.
• If you do not wish to use this
reset, press EXIT or MENU to back
out.
• If you do wish to use the reset,
press ENTER to erase all memo-
ries and settings.
website at www.mitsuparts.com or call
(800) 553-7278.
• For questions:
Call Consumer Relations at 800-332-2119.
E-mail: MDEAservice@mdea.com
Website: www.mitsubishi-tv.com
Important
All lamps replaced under warranty must be returned
to Mitsubishi where they will be inspected for defect
verification.
Resulting Action
Allows the front panel to be unlocked
if the remote control is misplaced.
The TV will turn off and the green LED
will flash quickly for about one minute.
When the green LED stops flashing,
you may turn on the TV. The changes
you made most recently, before using
SYSTEM RESET, may be lost. Changes
you made previously, however, are
not lost.
The TV will start the initialization
process. The TV will then turn off
and the front green LED will start
flashing. When the LED stops
flashing, you can turn the TV on
again. The Parental Lock Pass code
will remain unaffected, but all other
memories and settings outlined in
this Owner's Guide will need to be
set again.