Mitsubishi HS-U449 Owner's Manual page 39

Advanced Features
repeat playback
You can playback a section of tape over and over using repeat
playback. The tape will play until the next index mark, rewind to
the previous index mark, and resume playing. If there is only one
index mark on the tape, then the VCR will play or rewind to that
mark and resume playback. If there is no index mark, the entire
cassette will repeat.
1 Press AUDIO/VIDEO on the remote control to display the
function menu. Press AUDIO/VIDEO until the Repeat play
function appears.
2 To start the playback, press ENTER.
When the VCR encounters the next mark or the end of the
tape, it will automatically rewind to the previous mark and begin
playback again.
The VCR will also search for a blank section of tape. If the
VCR encounters any blank sections longer than 4 seconds in
length, the repeat playback will begin.
3 Press STOP to cancel the repeat.
Search to blank
This feature allows you to find the end point of the recorded part of
the tape. The VCR will stop automatically at the beginning of the
blank section of a tape.
1 Press AUDIO/VIDEO on the remote control to display the
function menu. Press AUDIO/VIDEO until the Search to blank
function appears.
2 To start the search, press ENTER.
When the VCR encounters the blank section of a tape, it will
automatically stop.
This feature may not work correctly when the end point of
the recorded part is within 5 minutes in SP mode (15
minutes in EP mode) from the current position.
IMPORTANT
VCR
Repeat play
Use ENTER to start
VCR
Search to blank
Use ENTER to start
37