Mitsubishi Electric XD450U User Manual page 17

1 IMAGE
CONTRAST .......... Use to adjust the image contrast. The contrast becomes
higher as the value increases.
BRIGHTNESS ....... Use to adjust the image brightness. The image becomes
brighter as the value increases.
CineRichColor ...... Use to adjust the white level of the projected image. Select
AUTO for normal use.
sRGB .................... Choose ON for projection emphasizing on the color
reproducibility.
• When sRGB is ON, CineRichColor, COLOR MATRIX,
COLOR MATRIX ... Use to adjust the color balance in each color of the image.
See page 19.
COLOR TEMP. ...... Use to adjust the color temperature. See page 19.
COLOR ................. Use to adjust the color intensity of the image.
TINT ...................... Use to adjust the color balance of the image. The color balance shifts to green as the value
increases and shifts to purple as the value decreases. (Available only when VIDEO or S-VIDEO
is chosen as the source.)
• When the TV50 (PAL, SECAM) signal is input, TINT can't be adjusted.
SHARPNESS ........ Use to adjust the image sharpness. The image becomes sharp as the value increases. (Available
only when VIDEO or S-VIDEO is chosen as the source.)
GAMMA MODE .... When AUTO is selected, the appropriate gamma mode is automatically selected depending on
the input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select
STANDARD for sport scenes and video sources. Select THEATER for film sources.
2 INSTALLATION
AUTO POWER ON ..... When ON is chosen, the lamp is automatically lit when the
power cord is plugged in the wall outlet. Choose ON when
using the projector mounted on the ceiling.
• The projector is in the stand-by mode when the lamp is
AUTO POWER OFF .... Use to set the time elapsed before the projector enters
the stand-by mode when there is no signal input from the
source.
IMAGE CAPTURE Use to capture the screen for the splash screen. See page
22.
SPLASH SCREEN Choose ON to display the splash screen when the power is
turned on.
• The splash screen can be changed. See page 22.
BACK COLOR ...... Use to select the background from among BLUE, BLACK and IMAGE, which will be displayed
when there is no signal input from the source. When IMAGE is selected, the splash screen will
be displayed.
MUTE MODE ........ Use to choose the background, either BLACK, or IMAGE, which will be displayed when the
MUTE button is pressed. When IMAGE is chosen, the splash screen will be displayed.
LAMP MODE ........ Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept
low and the projector operating noise is reduced, resulting in a longer lamp replacement interval.
(For XD450U only)
• When the lamp mode is switched, the projected image may flicker. This is not a product mal-
• Do not change the setting of LAMP MODE frequently.
IMAGE REVERSE .... Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-
mounted projector. Select MIRROR INVERT for front projection with the ceiling-mounted
projector.
• You can't set IMAGE CAPTURE or SPLASH SCREEN when PASSWORD FUNCTION in the FEATURE menu has
been set to SPLASH ID SCREEN to enable the password lock.
COLOR TEMP., COLOR, TINT and GAMMA MODE can't
be adjusted.
off. Use the remote control to turn on the lamp.
function.
opt.
XGA60
IMAGE
CONTRAST 0
BRIGHTNESS 0
CineRichColor AUTO
sRGB OFF
COMPUTER
COLOR MATRIX
COLOR TEMP. STANDARD
COLOR 0
TINT 0
SHARPNESS 0
GAMMA MODE AUTO
opt.
XGA60
INSTALLATION
AUTO POWER
OFF
ON
AUTO POWER
OFF
OFF
IMAGE
SETUP
CAPTURE
SPLASH
ON
ON
SCREEN
BACK COLOR BLUE
BLACK
MUTE MODE
STANDARD
LAMP MODE
IMAGE
OFF
REVERSE
EN - 17