Panasonic TH-50CX700A Operating Instructions Manual page 5

Hide thumbs Also See for TH-50CX700A:
Table of Contents

Advertisement

Data transmitted and received over radio waves may
be intercepted and monitored.
The built-in wireless LAN uses 2.4 GHz and 5 GHz
frequency bands. To avoid malfunctions or slow
response caused by radio wave interference when
using the built-in wireless LAN, keep the TV away
from other devices that use 2.4 GHz and 5 GHz
signals such as other wireless LAN devices,
microwave ovens, and mobile phones.
When problems occur due to static electricity, etc., the
TV might stop operating to protect itself. In this case,
turn the TV off at the Mains power On / Off switch,
then turn it back on.
Additional information for the wireless LAN and
access point may be on the following website.
http://panasonic.net/viera/support
Bluetooth
wireless technology
®
Caution
The TV, 3D Eyewear and Touch Pad Controller use
the 2.4 GHz radio frequency ISM band (Bluetooth
To avoid malfunctions or slow response caused by
radio wave interference, keep the TV, 3D Eyewear
and Touch Pad Controller away from the devices
such as other wireless LAN devices, other Bluetooth
devices, microwaves, mobile phones and the devices
that use 2.4 GHz signal.
Ventilation
Caution
Allow sufficient space around the TV in order to help
prevent excessive heat, which could lead to early failure
of some electronic components.
Minimum distance:
10
10
10
10
Ventilation should not be
impeded by covering the
ventilation openings with
items such as newspapers,
tablecloths and curtains.
Whether you are using a pedestal or not, always
ensure the vents at the bottom of the TV are not
blocked and there is sufficient space to enable
adequate ventilation.
Moving the TV
Caution
Before moving the TV, disconnect all cables.
Move the TV with at least two people.
This TV will still consume some power even in the Off
mode, as long as the mains plug is still connected to a
live mains socket.
).
®
(cm)
When not in use for a long time
Caution
Remove the mains plug from the wall socket when
the TV is not in use for a prolonged period of time.
Battery for the Remote Control /
3D Eyewear / Touch Pad Controller
Caution
Incorrect installation may cause battery leakage,
corrosion and explosion.
Replace only with the same or equivalent type.
Do not mix old and new batteries.
Do not mix different battery types (such as alkaline
and manganese batteries).
Do not use rechargeable batteries (Ni-Cd, etc.).
Do not burn or break up batteries.
Do not expose batteries to excessive heat such as
sunshine, fire or the like.
Make sure you dispose of batteries correctly.
Remove the battery from the unit when not using for
a prolonged period of time to prevent battery leakage,
corrosion and explosion.
3D Eyewear Use
Caution
Use the 3D Eyewear only for the intended purpose
and nothing else.
Do not move around while wearing the 3D Eyewear to
avoid falling or accidental injury.
Do not drop, bend, apply pressure on, or step on the
3D Eyewear.
Be careful of the tips of the frame when putting on the
3D Eyewear.
Be careful not to trap your fingers in the hinge section
of the 3D Eyewear.
Do not use the 3D Eyewear if it is physically
damaged.
If you suffer from any eyesight problems (short / far-
sighted, astigmatism, eyesight differences in left and
right), ensure that you correct your vision before using
the 3D Eyewear. The supplied 3D Eyewear can be
worn over vision correction glasses.
Stop using the 3D Eyewear immediately if you
experience any redness, pain or skin irritation around
the nose or temples. In rare cases, the materials used
in the 3D Eyewear may cause an allergic reaction.
Do not use the 3D Eyewear at high temperatures.
Always keep the 3D Eyewear in a cool and dry place.
Stop using the 3D Eyewear immediately if a
malfunction or fault occurs.
5
English

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents